This would let me offset the plate to one side, which would allow better airflow. Or, I could drill vertical holes in the horizontal "fins" of the air dam, and wrap the wires through those holes. One thought I have may be to surround the plate edges with a soft plastic or foam material, and then run plastic-coated wire through the eyelets in plate, and basically wire-wrap them to the horizontal and vertical supports in the air dam. What I cannot figure out, however, is how to effectively affix the plate to the air dam. Works great with our JDM Legends Plate Filler. A simple and clean way to tidy up the rear end of your ride. I read the California DMV regulations regarding the front plate, and see no problem with this whatsoever. Put the finishing touch around your license plate with our JDM Legends frame with 3D logo. In the photo below, which has the license bracket attached on the bumper, it looks like the air dam is high enough to hold the plate, and the right and left sides of the air dam don't provide any cooling at all, so a plate to the left or right side wouldn't interfere with cooling. ![]() Since I have a liftback and there's a zillion around here, I was originally going to go with a non-black color to make the car easier to find in parking lots. ![]() This provides room to install the front license plate without putting the plate right on the bumper. 164 25 1 Location: San Diego Vehicle: 2014 Prius Model: Three When I was waiting for my plates last month, I thought about ordering a frame online with a custom quote printed on it. I took a look at the new 2012 Prius, and the front air dam has been re-designed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |